Get Leverage Working for You


Leverage is an investment term that describes the use of borrowed funds to control an asset; sometimes referred to as using other people’s money. Borrowed funds can affect the investment in your home positively.

For instance, if you had a $100,000 rental property, collected the rents and paid the expenses and had $10,000 left, you would earn a 10% return (divide the $10,000 by the $100,000.) With no loan on the property, there is no leverage.

If you decided to get an 80% mortgage at 8%, you would owe an additional $6,400 in expenses leaving you only $3,600 net. However, your return would grow to 18% because your investment is now $20,000 in cash (divide the $3,600 by $20,000.)

Leverage, the use of borrowed funds, causes the return to increase in this example. While, most people associate leverage with rental properties, it also applies to a home. The larger the mortgage, the more leverage you have. A FHA mortgage with a 3.5% down payment has more leverage than an 80% loan.

Assume we’re looking at a $295,000 purchase price with 3% closing costs and a 4.5% mortgage for 30 years with a five-year holding period. The following table shows the return based on different down payments and appreciation rates. The initial investment is the down payment plus closing costs. The equity build-up at end of year five is the result of normal principal reduction and appreciation.

Down Payment 1% Appreciation 2% Appreciation 3% Appreciation
3.5% 21% 28% 34%
10% 12% 17% 21%
20% 7% 10% 13%

Another way to look at the 3.5% down payment example with 3% appreciation would be to say that a $10,325 down payment plus $8,850 in closing costs could grow into $82,482 of equity in a five-year period producing a 34% rate of return on the initial investment.

Estimate what your initial investment could grow to using this fred

Advertisements

Delay Will Usually Cost More


Two things can happen when the mortgage rates go up before you’ve found a home or locked-in your mortgage. You’ll either pay the current mortgage rate which means a higher payment, or you’ll have to increase your down payment to keep the monthly payment at the same level.

If the rate were to go up by ½%, the payment on a $275,000 mortgage would increase by $82.87 per month for the entire 30-year term. That would increase the cost of the home by $29,835.

Some people are purchasing the maximum home that they can qualify for. In that case, they cannot qualify for a higher payment and the only way to buy the same price home is to put more money down which may not be a possibility. The other alternative is to buy a lower price home which may not be in the same area or size which will involve some compromises.

The rate is not the only dynamic that affects buyers waiting to purchase. The home they want could sell to someone else. Prices could increase as new homes come on the market. The question that many buyers ask themselves when they become a victim of the consequences of delay is “What could we have spent the money on if we didn’t have to make a higher payment?”

Mortgage rates are very attractive currently and within ½% of the all time low of 3.35% in December 2012. The highest rate was 18.45% in October 1981. Whether you’re purchasing or refinancing, it may not be this low again.

To see how it will affect the payment, plug your numbers into this Cost of Waiting to Buy calculator or call me at (503) 289-4970 and I’ll help you with it.

New Bill Says Negative Credit Should Be Removed After Four Years


This is Good News! Could make a big positive difference in the lives of many Americans.

Ask Carolyn Warren

Last Thursday, a new Bill (H.R. 3622) was introduced to the Financial Services

House Representative Rashida Tlaib, Michigan

Committee. This bill would shorten the time period that negative information can report on a person’s credit report.

Currently, late payments, collections, charge-offs, and other adverse credit can remain in your credit file for seven years. This bill, if passed, would reduce that to four years.

Is four years long enough for consumers to have their credit scores docked for a mistake or hardship of the past?

Is four years long enough for creditors to have leverage in collecting past due funds?

The bill was sponsored by House Representative Rashida Tlaib, Michigan on July 5, 2019.

Thank you to Credit Repair Services, LLC for bringing this to my attention.

“With your help and the ease of understanding your book, I was able to get a $2,500 deletion off my credit, among others…

View original post 13 more words

Measuring Square Footage


Square footage is commonly used to determine if a home will fit a buyer’s needs. The price per square foot can be used to compare the costs of different homes and even, determine the value of a property.

The challenge is what is the source of the square footage measurement and how was it done.

County records use square footage to determine assessed value for property tax purposes. They are assumed to be reliable but there can be inaccuracies in their tax rolls. Another source of square footage could be from the house plans but the problem there is that the builder may have made modifications, or a subsequent owner could have made additions.

Appraisers are required to measure the home to determine square footage and they generally, adhere to a standard method which leads to uniformity in the industry. The ANSI, American National Standards Institute, guidelines are considered the standard but there are no laws governing the process.

Because basements are below grade level, regardless of whether they are finished, they are typically not counted toward gross living area. Attics because they are above grade level can be included in gross living area if they are finished to the same standard as the rest of the home and they meet the minimum height requirement of seven feet.

Unfinished areas are usually not considered in the square footage because it is not livable.

For detached properties, it is common to measure the perimeter of the house but to only include the living areas, not porches, patios or garages. Gross living area includes stairways, hallways, closets with minimum height and bathrooms. Covered, enclosed porches would only be considered if they use the same heating system as the house.

By contrast, condominiums, generally measure the inside area of the unit. Some appraisers may add six inches to account for the wall thickness. If you were to compare the total of the interior room measurements of a detached home, it would be far less than the stated square footage using the normal method.

If the county records are significantly different from the appraisal or the plans, it will be necessary to determine which one is more accurate. This may require getting the home measured by an appraiser which should be less than paying for a complete appraisal.

Checking for Water Leaks


Aside from standing water in your yard or water running out from under a sink, the first indication that you might have a water leak comes from a larger than normal water bill. Before calling a leak specialist or a plumber, there is a simple diagnostic you can perform.

Go through your home and make certain that all the faucets are turned off and that the toilets have indeed stopped filling the reserve. Then, go to the water meter and make a mark on the lens where the dial is currently. If there is water in the meter box, the meter itself could be leaking.

If the meter is still turning, the leak is between the meter and the house. By inspecting the area between the meter and the house, you can look for soft, muddy areas or grass that is greener than the rest of the yard.

One of the hardest places to isolate a leak is in a swimming pool. If you have an automatic filler, like in a toilet, you’ll need to turn it off. Mark the water line on the wall and wait to see if the water level goes down. There will be a certain amount attributable to evaporation.

Some leaks can be very difficult to locate. Plumbers, by the very nature of their job, will be more familiar with tracking down the source of the leak than a homeowner. There are some non-invasive techniques like acoustic listening devices, heat scanners and miniature video cameras on fiber optics that professionals can use.

Leaks can be expensive from the loss of water and the resulting damage that it can cause. Determining where the location of the leak can also cause damage because plumbing is usually concealed in walls or under concrete. For particularly difficult to locate leaks, discuss how the professional intends to locate the leak and minimize damage in the process.

Checking for Water Leaks


Aside from standing water in your yard or water running out from under a sink, the first indication that you might have a water leak comes from a larger than normal water bill. Before calling a leak specialist or a plumber, there is a simple diagnostic you can perform.

Go through your home and make certain that all the faucets are turned off and that the toilets have indeed stopped filling the reserve. Then, go to the water meter and make a mark on the lens where the dial is currently. If there is water in the meter box, the meter itself could be leaking.

If the meter is still turning, the leak is between the meter and the house. By inspecting the area between the meter and the house, you can look for soft, muddy areas or grass that is greener than the rest of the yard.

One of the hardest places to isolate a leak is in a swimming pool. If you have an automatic filler, like in a toilet, you’ll need to turn it off. Mark the water line on the wall and wait to see if the water level goes down. There will be a certain amount attributable to evaporation.

Some leaks can be very difficult to locate. Plumbers, by the very nature of their job, will be more familiar with tracking down the source of the leak than a homeowner. There are some non-invasive techniques like acoustic listening devices, heat scanners and miniature video cameras on fiber optics that professionals can use.

Leaks can be expensive from the loss of water and the resulting damage that it can cause. Determining where the location of the leak can also cause damage because plumbing is usually concealed in walls or under concrete. For particularly difficult to locate leaks, discuss how the professional intends to locate the leak and minimize damage in the process.

Building Equity


Owning a home is the first step to building equity. Tenants build equity but not for themselves; they build it for the owners.

Equity is the difference in the value of the home and what is owed on the home. There are two dynamics that cause this to grow: appreciation and principal reduction.

As the home increases in value, it is said to appreciate. Various authorities will annualize an appreciation rate based on average sales prices from one year to the next. Since appreciation is based on supply and demand as well as economic conditions, it will not be the same year after year.

If you looked at a ten to twelve-year period, some would be higher than others and there may even be some individual years that it is flat or even declined. For the most part, values tend to appreciate over time.

Most mortgages are amortized which means that a portion of the payment each month is applied to the principal in order to pay off the loan by the end of the term. A $300,000 mortgage at 4.5% for 30 years has $395.06 applied to the principal with the first payment. A slightly larger amount is applied to the principal each following month until the loan is paid with the 360th payment.

If additional principal payments are made, it will save interest, build equity faster and shorten the term of the mortgage. Using the previous example, if an additional $250.00 principal contribution was made with each payment, it would only take 270 payments to retire the loan instead of 360. It would save $69,305 in interest and shorten the mortgage by 7.5 years.

To see the dynamics of equity due to appreciation and principal reduction, look at the Rent vs. Own. To see the effect of making additional principal contributions on your equity, look at the Equity Accelerator.